Question: How to configure ESP for compatibility with eBUS adapter 2

[tgober]

I use a eBUS adapter 2 and try to connect it with a nodeMCU (because the D1 stopped working).
Should the adapter3 FW work with the old boards?
I tried the modes "direct RX/TX" and "swapped D7/D8".
Then I ran the ebusd in a docker env. For the RX part only the swapped option seems to work, but the TX doesn't send anything on the bus.
Then I passed the --generatesyn option into the container and stopped the syncer on the but. The log tells me, that an ">aa" was send, but I also receive an "unable to receive sent AUTO-SYN symbol: ERR: read timeout" error.
Also I can't see any SYNC char on the bus nor on the UART.

Can you help?

[john30]

yes, the firmware is backwards compatible. you just need to configure it correctly according to the connections on the adapter (depends on how the jumpers are set)

[meyerd]

I am using a custom made pcb inspired by the ebus adapter 2.2 version with a esp32-devkitc with a wroom 32d esp32. The firmware seems to work fine but i have different pins for rx/tx. Can you give me hints how to configure different pins (in my case it is GPIO16 + 17)? I would like to avoid adding botch wires to my pcb design.

for reference: the pinout of my board https://docs.espressif.com/projects/esp-idf/en/latest/esp32/_images/esp32-devkitC-v4-pinout.png

[john30]

only the options listed in the UI are usable for RX/TX

[meyerd]

... ah too bad, for the esp32, any IO pins can be reconfigured for one of the UARTs. But i see, that there are restrictions when using the esp8266.