crush after installing on MacOS Sonata 14.4.1

[jiashuow]

After installing the slic3r 1.3.0 dmg file from the website and Dropbox, I can't open it when I click the logo of slic3r. It's not because the system security stopped me from doing so. I have fixed that.

Is it because the slic3r doesn't support the newest edition of the MacOS system?

[AleyRobotics]

same bug #5172

[elpollitodiablo]

So I just checked this repo, and it seems abandoned, you may want to use PusaSlicer

[dwillmore]

As long as you want to support the project that killed off this project, sure go do that. Or, go use SuperSlicer or *any* other slicer.

…

On Mon, May 13, 2024 at 12:57 PM Dan.elpollitodiablo < ***@***.***> wrote: So I just checked this repo, and it seems abandoned, you may want to use PusaSlicer <https://github.com/prusa3d/PrusaSlicer/releases> — Reply to this email directly, view it on GitHub <#5187 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ACPEX7ALOXPD7WXEYVQKPGTZCDWJNAVCNFSM6AAAAABF5TJ4OKVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDCMBYGIZDQMJWGE> . You are receiving this because you are subscribed to this thread.Message ID: ***@***.***>

[snoopyonline78]

Same problem

[SoCuul]

After installing the slic3r 1.3.0 dmg file from the website and Dropbox, I can't open it when I click the logo of slic3r. It's not because the system security stopped me from doing so. I have fixed that.

Is it because the slic3r doesn't support the newest edition of the MacOS system?
@snoopyonline78

Slic3r has been abandoned for a long while now. I'd recommend you try https://github.com/SoftFever/OrcaSlicer for the one of the best slicers. It's based on BambuStudio, which in turn is based on Slic3r.